Volkswagen Golf Service & Repair Manual: Charging battery in support mode with battery charger -VAS 5095A-
The support mode provides the onboard supply with power when
the battery is removed or disconnected. |
For further information, refer to the
→ operating manual VAS 5095A. |
The support mode is suitable in the following situations: |
Support mode of onboard supplies without installed battery |
Power conservation when renewing the battery |
Ancillaries test without battery |
WARNING
Danger of injury! Observe warning notices and safety
regulations
→ Chapter! |
|
WARNING
It is not permissible to test or charge batteries
whose magic eye shows light yellow. Do not slave/jump
start the vehicle! |
Danger of explosion when checking and charging or
slave/jump starting. |
These batteries must be renewed. |
|
– |
Switch off ignition and all electrical consumers. |
Caution
The terminal polarity protection in operating mode
“charging totally discharged batteries/support mode” is
not active. Connect battery charger terminal clamps
correctly to battery terminals. |
It can cause sparks through a short-circuit. |
Ensure charger terminal clamps are seated securely. |
Do not press START / STOP
button when charger unit cables are connected
incorrectly. The charger unit may be damaged. |
|
Caution
When battery is removed, ensure there is no contact
between terminal clamp connected to positive clamp and
body earth. Also ensure there is no contact between
battery clamps. |
|
– |
Connect red terminal clamp “+” to positive terminal of
vehicle. |
Note
In vehicles with start/stop function and battery monitor
control unit -J367- fitted, black terminal clamp “-” must be
connected to body earth. Connecting it to battery negative
terminal will cause start/stop system to malfunction. |
– |
Connect black terminal clamp “+” to negative terminal of
vehicle. |
– |
Check setting for battery type on normal/support mode switch
→ Chapter. It must be switched on support mode. |
– |
Check polarity of charger unit cables. |
– |
Switch on battery charger. |
The battery charger starts with support mode. |
End battery support mode: |
– |
Switch off battery charger. |
– |
Disconnect black terminal clamp “-” of charger unit from
negative terminal of vehicle. |
– |
Disconnect red terminal clamp “+” of charger unit from
positive terminal of vehicle. |
– |
Pull charger plug out of battery charger. |
|
|
|
WARNING
Danger of injury! Observe warning notices and safety
regulations
→ Chapter!
...
WARNING
Danger of injury! Observe warning notices and safety
regulations
→ Chapter!
...
Other materials:
Loosening and tightening threaded connections of drive shaft
Special tools and workshop equipment
required
Socket, 24 mm -T10361A-
Angle wrench -V.A.G 1756 A-
...
Paint thickness tester -VAS 6272
Designation:
Paint thickness tester -VAS 6272-
Product description
The paint thickness tester VAS 6272 is a combination tester
for the non-destructive measurement of paint thickness on steel,
...
Securing child seats with a seat belt
First read and observe the introductory information
and safety warnings It is permissible to fasten child seats with
universal written on the orange label to the seats using the seat belt,
but only on the seats marked in the table with a u.
Weight class
Fr ...
© 2016-2024 Copyright www.vwgolf.org