Volkswagen Golf Service & Repair Manual: Changing headlights over from driving on left to driving on right, LED headlights

Volkswagen Golf Service & Repair Manual / Electrical system / Lights, lamps, switches outside / Headlight / Changing headlights over from driving on left to driving on right, LED headlights

If a right-hand drive vehicle is driven in a left-hand drive country, or vice versa, the headlights must be converted. This is necessary in order to avoid dazzling oncoming traffic with the asymmetric low beam headlights.

Note

The conversion from driving on left to driving on right, or vice versa, is performed by means of the infotainment system.

It is only permissible to make use of the headlight converter for a short period of time. When permanently driving in the respective country during a longer period of time, suitable headlights need to be installed according to valid specifications.

–	On the display unit for front information display and operating unit control unit -J685-, press button CAR.

–	Press function buttons Setup and Light.

–	Perform adjustment in menu “Light Settings”.

Changing headlights over from driving on left to driving on right (gas discharge headlights with dynamic high beam control and LED daytime running light)

If a right-hand drive vehicle is driven in a left-hand drive country, or vice versa, the headlights must be converted. This is necessary in order to avoid dazzling on ...

Removing and installing headlight range control motor -V48-/-V49- (dual halogen headlights)

Note Removal and installation are described for the left side. Removal and installation on the right side are carried out in the same way. ...

Other materials:

Overview of the driver side
Fig. 5 Overview of the driver side (left-hand drive vehicles) Fig. 6 Overview of the driver side (right-hand drive vehicles) Key for and : Button for interior monitoring Light switch Daytime running lights or daytime headlights Automatic hea ...

Assembly overview - dual clutch
1 - Hinge mounting For large engaging lever “K 1” Cannot be renewed. 2 - Ball pin For small engaging lever “K 2” Removing and installing → Anchor ...

Removing and installing fuel gauge sender -G-, vehicles with four-wheel drive
Removing – Remove fuel delivery unit → Chapter. – Disconnect connector -4- from right flange. – Disengag ...