Engine preheating
IntroductionRemoving and installing wheel bearing housing, multi-link suspension,
front-wheel drive
Special tools and workshop equipment
required
Torque wrench -V.A.G 1332-
Engine and gearbox jack -V.A.G 1383 A-
...
Assembly overview - oil filter/oil pressure switch
1 -
Oil filter
Remove and install with oil filter tool -3417-.
Before installing, lightly coat seal with clean engine oil.
20 Nm
See note
→ Anchor
2 -
Oil pre ...
Removing and installing Bowden cable for remote release mechanism for seat
backrest
Note
Removal and installation are described for the left vehicle side.
Follow same instructions for the right side as appropriate.
Removing
Bowden cable on backrest end
–
Remove rear seat backrest
→ Chapter.
...