Fig. 237 In the tailgate: removing the cover
Fig. 238 In the tailgate: removing the bulb holder
First read and observe the introductory information and safety warningsThe actions should only be carried out in the specified order: | |
---|---|
1. | Observe and follow the instructions on the checklist. |
2. | Open the tailgate. |
3. | Carefully prise off the cover in the direction of the arrow using the flat blade of the screwdriver from the vehicle toolkit . |
4. | Pull out the fuse . Press the catches ③ on the connector and pull out the connector. |
5. | Release the retaining lugs on the bulb holder in the direction of the arrow and pull out the bulb holder. |
6. | Replace the defective bulb with a new bulb of the same type. |
7. | Replace the bulb holder. The retaining lugs must audibly click into place. |
8 | Attach the connector to the bulb holder and fit the cover. The cover must engage fully and securely. |
There are various types of rear light, so the position and design of covers, bulbs and bulb holders may vary from those shown in the illustrations.
In tail lights with LED technology, the reversing light is fitted with a normal bulb. This bulb can be changed.
Removing and installing protective cap
Special tools and workshop equipment
required
Removal wedge -3409-
Thrust piece -T10502- for rear brake FNc-M38 (15”)
...
Removing and installing drive shaft, right drive shaft, constant velocity
joints VL100 and VL107, e-Golf
Special tools and workshop equipment
required
Torque wrench -V.A.G 1332-
Press tool -T10520-
...
Assembly overview - air duct and air distribution in passenger compartment
Note
The illustration shows a left-hand drive vehicle.
1 -
Air duct for defroster vent
Removing and installing
→ Chapter.
2 -
Air duct f ...