Volkswagen Golf Owners Manual: Changing a wheel

Volkswagen Golf Owners Manual / If and when / Practical tips / Changing a wheel / Changing a wheel

Fig. 226 Changing a wheel: removing the wheel bolts with the screwdriver handle

First read and observe the introductory information and safety warnings

Removing the wheel

Read the checklist.

Loosen the wheel bolts.

Jack up the vehicle.

Using the hexagonal socket in the screwdriver handle , completely unscrew the loosened wheel bolts and place them on a clean surface.

Remove the wheel.

Fitting the spare wheel or temporary spare wheel

Note any specific tyre running direction .

Position the spare wheel / temporary spare wheel.

Insert the anti-theft wheel bolt using the adapter at position or ③ and tighten it slightly in a clockwise direction.

Screw in all the other wheel bolts in a clockwise direction and use the hexagonal socket in the screwdriver handle to tighten them gently.

Lower the vehicle with the jack.

Use the box spanner to tighten all the wheel bolts securely in a clockwise direction . Do not tighten the bolts in clockwise or anticlockwise sequence. Tighten them in diagonal sequence.

Fit the cover caps, centre covers or wheel covers.

WARNING

Incorrect torque or incorrect use of wheel bolts can lead to a loss of control of the vehicle, cause accidents and serious injuries.

Always keep all wheel bolts and threads in the wheel hubs clean and free from oil and grease. The wheel bolts must be easy to turn and be tightened to the specified torque.

The hexagonal socket in the screwdriver handle should only be used for turning wheel bolts, not use for loosening or tightening them.

Checklist

To ensure your own safety and the safety of your passengers, observe the following actions in the specified order : Find a firm and level surface suitable for lifting the vehicle. Swit ...

After changing a wheel

First read and observe the introductory information and safety warnings Clean the tools as necessary and place them back in the foam rubber holder in the luggage compartment. Stow the spa ...

Other materials:

Removing and installing high-level brake light, GTI, GTD and »R«
Removing: – Remove roof spoiler → General body repairs, exterior; Rep. gr.66. – Unscrew bolts -1-, -5- and -6- from high-level brak ...

Removing and installing drive shafts, triple roller joint AAR3300i bolted
Special tools and workshop equipment required Torque wrench -V.A.G 1332- Press tool -T10520- ...

Without roller dynamometer for four-wheel drive vehicles
Note If no test rig is available for four-wheel drive vehicles, the brake test can also be carried out on a standard single-axle roller dynamometer as follows: – Drive vehicle forwards onto the rollers. ...