Volkswagen Golf Owners Manual: Changing a blown fuse

Volkswagen Golf Owners Manual / If and when / Practical tips / Fuses / Changing a blown fuse

Fig. 232 Blown fuse: A: flat blade fuse, B: JCASE® fuse

Fig. 233 Remove or insert fuse with plastic pliers: A. flat blade fuse, B. JCASE® fuse

First read and observe the introductory information and safety warnings

Preparation

Switch off the ignition, the lights and all electrical consumers.

Open the appropriate fuse box.

Detecting a blown fuse

Shine a torch onto the fuse. This will help you to spot the blown fuse more easily.

A blown flat blade fuse (ATO^®, MINI^®) can be recognised from the top and side through the transparent housing surrounding the melted metal strips A.

A blown JCASE^® fuse can be recognised from the top through the transparent housing B.

Changing a fuse

In some vehicles, a pair of plastic pliers for removing fuses is located on the inside of the cover of the fuse box in the engine compartment.

Open the fuse box cover in the engine compartment and remove the plastic pliers.

Push the plastic pliers suitable to the fuse design A ① or B ① onto the fuse from the side.

Lift the fuse up and out.

If the fuse has blown, replace it with a new fuse of the same amp rating (same colour and same markings) and same size .

Once the new fuse is inserted, clip the plastic pliers into the holder on the inside of the fuse box cover.

Fit the fuse box cover.

NOTICE

You can damage another position in the electrical system by using a fuse with a higher amp rating.

Fuse tables for fuses in the engine compartment

Fig. 231 Engine compartment: fuse layout First read and observe the introductory information and safety warningsThe table shows the fuse locations for the items of electrical equipment which ar ...

Changing bulbs

...

Other materials:

Checklist
To ensure your own safety and the safety of your passengers, observe the following actions in the specified order : Stop the vehicle at a safe distance away from moving traffic and on a suitable surface . Switch on the hazard warning lights using the button . Switch on the ...

Instructions for work on underbody and stone chip protection
Note The structure of the underbody and stone chip protection is to be reconstructed to conform to the original condition in appearance and thickness. Water drainage holes must remain clear. ...

Removing and installing gas strut
Removing – Open and support bonnet. WARNING Proceed with care if gas strut is reused. Spring clip must not be levered completely out of ball socket, as it will otherwise be damaged. Gas strut will spring ou ...