Volkswagen Golf Service & Repair Manual: Central locking

Removing and installing window slot inner seal

  Note Removal and installation are only described for the left window slot inner seal. Removal and installation of the right window slot outer seal are ...

Overview of fitting locations – central locking

1 -  Coupling station Fitting location: right A-pillar To separate connections, release bellows at pillar 2 -  Onboard supply control unit - ...

Other materials:

Assembly overview - suspension strut, shock absorber, spring, multi-link suspension
1 -  Bolt Renew after removing 50 Nm +45° 2 -  Shock absorber Removing and installing → Chapter Note correct installation position of cable tie fastener. ...

Removing and installing front air distribution flap control motor -V426-, LHD vehicles
Special tools and workshop equipment required Vehicle diagnostic tester First carry out the following work: –  Switch off all electrical consumers. –  ...

Bleeding coolant circuit of auxiliary heater
The removal and installation procedures for the auxiliary heater and the circulation pump -V55- described in this Workshop Manual ensure that only a small quantity of air enters or remains in the coolant circuit. Therefore it is not necessary to bleed th ...