Volkswagen Golf Service & Repair Manual: Calibrating Blind Spot Monitor control unit -J1086-/-J1087-
Note
Before the actual calibration process of the control units,
the calibration unit -VAS 6350- needs to be set up as described
in the following chapter. |
Special tools and workshop equipment
required |
|
|
|
Calibration unit -VAS 6350- |
Vehicle diagnostic tester |
During the calibration process the following should not
occur: |
Vehicle doors should not be opened or closed. |
There should be no-one in the vehicle. |
No-one should pass through the space between the vehicle and
the calibration unit for lane change assist -VAS 6350/4-. |
|
|
|
During the program sequence you will be requested to change
the calibration unit for lane change assist -VAS 6350/4- from
the left to the right-hand side of the calibration unit -VAS
6350-. |
– |
Switch off the calibration unit for lane change assist -VAS
6350/4-, and change to the other side. |
If assembled correctly, the mains power lead should be
fitted to the bottom left of the calibration unit (as seen
facing direction of normal travel). |
Dimension -a- = 606 mm
(measured from upper edge of calibration unit to floor). |
Setting dimension right = 621 mm (read off from measuring
scale -1-). |
|
|
|
– |
Switch on the calibration unit for lane change assist -VAS
6350/4- using the mains switch -3-. |
The green LED -1- must light
up. |
– |
Proceed by following the instructions on the display of
vehicle diagnostic tester. |
Upon completion of lane change assist system calibration
switch off ignition and disconnect diagnosis connector. |
|
|
|
Extensive preliminary work is required before the actual
calibration can be carried out using → Vehicle
diagnostic tester.
Prerequis ...
Other materials:
Cleaning wheels
First read and observe the introductory information
and safety warnings Cleaning steel wheels
Accumulated brake dust can only be removed with an industrial cleaner. Steel
wheels should therefore be cleaned regularly with a separate sponge.
Any damage to the paint on steel wheels should be t ...
Refrigerant circuit with expansion valve and evaporator
1 -
Evaporator
2 -
Expansion valve
3 -
Valve for extracting, charging and measuring
4 -
Receiver with dessicant bag or cartridge
...
Assembly overview - fog lights, GTI and GTD
1 -
Bolt
Specified torque: 2 Nm
2 -
Bolt
Specified torque: 2 Nm
3 -
Fog lights
These LEDs cannot be renewed. If one of the LEDs fails, the entire
fog light needs to ...
© 2016-2024 Copyright www.vwgolf.org