Volkswagen Golf Service & Repair Manual: Bonnet. flaps.cab. central loking

Removing and installing plenum chamber cover

Removing   Note The removal and installation procedures for the plenum chamber covers may have to be modified slightly depending on model variants. ...

Bonnet

...

Other materials:

Calibrating Blind Spot Monitor control unit -J1086-/-J1087-
  Note Before the actual calibration process of the control units, the calibration unit -VAS 6350- needs to be set up as described in the following chapter. Special tools and workshop equipment required   ...

Assembly overview - flanging tool
The flanging tool for brake lines -VAS 6056- can be used to flange brake lines with an outer pipe diameter of 5 mm without damaging the coating. In certain cases, this allows sections of brake lines to be renewed at less expense.   N ...

Assembly overview - camshaft housing, engine codes CHPA, CMBA, CPVA, CXSA, CZCA, CPVB, CZDA
1 -  Bolt Specified torque and tightening sequence → Fig. 2 -  Inlet camshaft control valve 1 -N205- Removing and installing → Chapter 3 -  Bolt ...