Volkswagen Golf Service & Repair Manual: Bonnet
- Assembly overview - bonnet
- Assembly overview - Bowden cable
- Removing and installing bonnet
- Adjusting bonnet
- Removing and installing bonnet lock, LHD vehicle
- Removing and installing bonnet lock, RHD vehicle
- Removing and installing bonnet release lever
- Removing and installing striker pin
- Removing and installing hinges
- Removing and installing insulation
- Removing and installing gas strut
- Releasing gas from gas strut
- Removing and installing Bowden cable
Assembly overview - bonnet
1 -
Bonnet
Removing and installing
→ Chapter
Adjusting
→ Chapter
2 -
Adjustment buffer
Qty. 2
...
Other materials:
Overview of fitting locations - fuel supply system, Golf and Golf GTE
Note
Fuel lines are secured with O-type clips. These O-type clips
must always be renewed every time they are removed.
Start engine if fuel tank was empty. Then start the
auxiliary heater repeatedly until the heater d ...
Checking fuel system for leaks
Special tools and workshop equipment
required
Fuel system tester (so-called smoke tester) -KLI 9210-
Adapter hose -KLI 9210/55-1-
Hose clamps up ...
Overview of fitting locations – lights in roof trim
1 -
Driver side illuminated vanity mirror -W20-
In the case of vanity mirrors with LED lighting, the entire light
must be renewed in the event of a fault.
Removing and installing
→ Chapter
2 -
...
