Look carrierOverview of fitting locations - front control motors, LHD vehicles
1 -
Temperature flap control motor -V68-
Checking: with vehicle diagnostic tester
Removing and installing
→ Chapter
Renewing: initiate basic setting using vehicle diagnostic tester.
2 -&nbs ...
Overview of fitting locations - fuel supply system, Golf and Golf GTE
Note
Fuel lines are secured with O-type clips. These O-type clips
must always be renewed every time they are removed.
Start engine if fuel tank was empty. Then start the
auxiliary heater repeatedly until the heater d ...
Checking holding pressure
Special tools and workshop equipment required
Pressure tester -VAS 6550-
Removal wedge -3409-
Connector cable -VAS 6550/3-3-
Connector cable -VAS 6550/3-4-
Vehicle diagnostic tester
...