Volkswagen Golf Service & Repair Manual: Auxiliary heater

Removing and installing footwell vent temperature sender -G192

Special tools and workshop equipment required     Removal wedge -3409- Vehicle ...

Technical data

...

Other materials:

Assembly overview - toothed belt, engine codes CPTA, CHPA, CZEA, CZDA
1 -  Toothed belt Before removing, mark direction of rotation with chalk or felt-tipped marker pen. Check for wear Removing → Chapter Installing (adjusting valve timing), CPTA, CZEA & ...

Removing and installing B-pillar trim on rear door
  Note Removal and installation are described only for the left side. Removal and installation of the right side are similar. Removing –  Run door window down to bottom position. –  Pull window channel -3- in area ...

Leak detection in refrigerant circuit using compressed air or nitrogen
  Note A leak in the refrigerant circuit can be detected, for example, by pressurising the circuit to a maximum of 15 bar using cleaned and dried compressed air or nitrogen → Chapter. If the leak is large, the leakage point ...