Operation
Filling the tankVacuum system
Vacuum pump for brake servo, diesel
vehicles
Vacuum pump for 4-cylinder diesel engine (1.6 l, common
rail):
The vacuum pump is installed in the oil pump.
–
Removing and installing vac ...
Calibrating Blind Spot Monitor control unit -J1086-/-J1087-
Note
Before the actual calibration process of the control units,
the calibration unit -VAS 6350- needs to be set up as described
in the following chapter.
Special tools and workshop equipment
required
  ...
Assembly overview - poly V-belt drive, vehicles without air conditioner
compressor
1 -
Bolt
Renew
150 Nm +180°
Use counterhold -T10475- to loosen and tighten.
Risk of damage to engine caused by incorrect valve timing.Do not turn crankshaft
out of TDC position.
2 -
...