Volkswagen Golf Service & Repair Manual: Assembly overview - windscreen wiper system

Volkswagen Golf Service & Repair Manual / Electrical system / Windscreen wipe/ wash system / Windscreen wiper system / Assembly overview - windscreen wiper system

Note

The illustration shows fitting locations for LHD vehicles. Fitting locations for RHD vehicles are similar.

Assembly overview - windscreen wiper system

1 -	Wiper blade on driver side

Different lengths. Refer to → Electronic Parts Catalogue.

Removing and installing → Chapter

2 -	Wiper blade on front passenger side

Different lengths. Refer to → Electronic Parts Catalogue.

Removing and installing → Chapter

3 -	Wiper arm on front passenger side

Different lengths. Refer to → Electronic Parts Catalogue.

Removing and installing → Chapter

Adjusting → Chapter

4 -

Cap

5 -

Nut

Specified torque: 20 Nm

6 -

Bolt

Tightening sequence → Fig.

7 -

Bolt

Tightening sequence → Fig.

8 -	Wiper frame

With wiper motor -V-.

With wiper motor control unit -J400-.

Removing and installing → Chapter

9 -

Bolt

Tightening sequence → Fig.

10 -

Nut

Specified torque: 20 Nm

11 -

Cap

12 -	Wiper arm on driver side

Different lengths. Refer to → Electronic Parts Catalogue.

Removing and installing → Chapter

Adjusting → Chapter

Removing and installing wiper motor – specified torque and tightening sequence

–	Tighten bolts in stages in sequence shown:

Assembly overview - windscreen wiper system

Stage	Bolts	Specified torque
1.	-1 … 3-	Screw in by hand as far as stop.
2.	-1 … 3-	8 Nm

Windscreen wiper system

...

Assembly overview – wiper motor and wiper frame

Note The illustration shows fitting locations for LHD vehicles. Fitting locations for RHD vehicles are similar. 1 - Wiper motor ...

Other materials:

Assembly overview- net partition
1 - Net partition Removing and installing → Chapter 2 - Bolt 4.5 Nm 3 - Remove fitting eye trim Allocation → Electronic Parts Catalogue Removing and installing ...

Removing and installing driver side interior locking button for central locking system -E308-
Note The removal and installation procedures are described for LHD vehicles. Removal and installation for RHD vehicles are similar. Removing – Remove exterior mirror adjuster -EX11- ...

Checking airbag securing parts after an accident
All damaged securing parts must always be renewed. It is not permissible to bend the components back into shape or »make them fit« The following components must be checked after the relevant airbag has been triggered. ...