1 - | Dust cap |
Renew after removing |
Pressing off and driving in → Chapter |
A proper seal can be achieved only by installing a new dust cap. |
2 - | Bolt |
Renew after removing |
200 Nm +90° |
3 - | Wheel bearing unit |
Removing and installing → Chapter |
The wheel bearing and wheel hub are assembled in one housing. |
This wheel bearing unit is maintenance-free and does not require adjustment. Adjustments and repairs are not possible! |
4 - | Bolt |
Renew after removing |
30 Nm +90° |
5 - | Heat shield |
6 - | Stub axle |
7 - | Axle beam |
Overview of fitting locations – adaptive cruise control, variant 2
1 -
Dash panel insert -KX2-
With control unit in dash panel insert -J285-.
Removing and installing
→ Chapter
2 -
Front bumper carrier
3 -
Retaining plate
...
Assembly overview - storage compartment in roof headliner
1 -
Storage compartment
Removing and installing
→ Chapter
2 -
Cover
3 -
Bolt
Qty. 4
1.5 Nm
4 -
Front interior light -WX1-
Overview of fitting location ...
Assembly overview - dual clutch
1 -
Hinge mounting
For large engaging lever “K 1”
Cannot be renewed.
2 -
Ball pin
For small engaging lever “K 2”
Removing and installing
→ Anchor
...