1 - | Splash plate |
2 - | Bolt |
12 Nm |
3 - | Wheel bearing unit |
Removing and installing → Chapter |
Cannot be repaired |
4 - | Bolt |
Renew after removing |
Loosening and tightening → Chapter |
200 Nm +180° |
5 - | Wheel bearing housing |
Different versions, allocation → Electronic Parts Catalogue “ETKA”. |
Removing and installing → Chapter |
6 - | Bolt |
Renew after removing |
70 Nm +90° |
7 - | Drive shaft |
Do not let drive shaft hang down under its own weight when performing repair work, as otherwise excessive bending could damage inner CV joint |
Before fitting the outer joint in the wheel hub, apply a thin coat of assembly paste to the splines on the outer joint → Electronic Parts Catalogue “ETKA”. |
Removing and installing bracket for net partition
Removing
–
Remove luggage compartment side trim
→ Chapter.
–
Pull belt webbing aside, and unscrew bolts
-2-.
–
Pull bracket for net partition -1- ...
Removing and installing left temperature flap control motor -V158-, RHD
vehicles
Special tools and workshop equipment
required
Vehicle diagnostic tester
First carry out the following work:
–
Switch off all electrical consumers.
–
...
Removing and installing brake pads, FS III front brake
Special tools and workshop equipment
required
Torque wrench -V.A.G 1331-
Piston resetting appliance -T10145-
...