| 1 - | Front bumper cover |
| 2 - | Emblems on radiator grille |
| 3 - | Rear lettering |
| 4 - | Rear bumper cover |
| 5 - | Side member extension |
| 6 - | Lettering on wing |
Assembly overview – special add-on parts, “R”Assembly overview - rear vehicle level sender, torsion beam axle
Note
The rear left vehicle level sender -G76- is only available as a
replacement part complete with coupling rod and upper and lower
retaining plates.
1 -
Electrical connector
2 -
Bolt
5 Nm
...
Removing and installing intake manifold
Special tools and workshop equipment
required
Release tool -T10527-
Release tool -T10527/1-
Removing
–
Remove air filter housing
→ Chapte ...
Overview of fitting locations - front control motors, air conditioning
system with electric/manual controls, LHD vehicles
1 -
Temperature flap control motor -V68-
With potentiometer for temperature flap control motor -G92-.
Checking: with vehicle diagnostic tester
Removing and installing
→ Chapter.
Renewing: in ...