1 - | Headlight |
Removing and installing → Chapter |
2 - | Inner retaining tab |
Removing and installing → Chapter |
3 - | Bolt |
Qty. 2 |
2 Nm |
4 - | Rear retaining tab |
Removing and installing → Chapter |
5 - | Bolt |
Qty. 2 |
2 Nm |
6 - | Bolt |
2 Nm |
7 - | Upper retaining tab |
Removing and installing → Chapter |
8 - | Bolt |
Qty. 2 |
2 Nm |
9 - | Outer retaining tab |
Removing and installing → Chapter |
Removing and installing trim for operating and display unit
Removing
–
Starting at bottom, unclip trim for operating and display
unit -1- from operating and display
unit -2- and remove it.
Installing
Note
Before installing, chec ...
Removing and installing striker pin
Special tools and workshop equipment
required
Torque wrench -V.A.G 1331-
Note
Removal and installation are described only for the right
d ...
Removing and installing fuel gauge sender 2 -G169
Special tools and workshop equipment
required
Removal wedge -3409-
Special wrench -T10202-
Removing
...