1 - | Brake system pressure accumulator -VX70- |
Removing and installing → Chapter |
2 - | Brake line |
To hydraulic unit |
With thread M12 x 1 |
14 Nm |
3 - | Brake line |
To brake master cylinder |
With thread M12 x 1 |
14 Nm |
4 - | Bolt |
8 Nm |
5 - | Bracket |
Check for secure seating after installing |
6 - | Rubber damper |
Do not press rubber dampers out of bracket when installing bracket. |
7 - | Bracket |
8 - | Nut |
20 Nm |
9 - | Bolt |
8 Nm |
10 - | Nut |
20 Nm |
11 - | Electrical connector |
Removing and installing head restraint guide
Removing
–
Remove backrest cover and backrest padding
→ Chapter.
Right head restraint guide
–
Press locking lugs inwards -arr ...
Removing and installing brake system pressure accumulator -VX70-, RHD
vehicles
Special tools and workshop equipment
required
Torque wrench -V.A.G 1331-
Torque wrench -V.A.G 1410-
...
Renewing LSF Lambda probe (4-pin)
Note
If necessary, replace attachment parts, cable ties or
marking rings to match the uniform probe to the defective probe
as specified.
Do not repair Lambda probe wires, since this can result in
malfunctions.
...