1 - | Retaining clip |
2 - | Bolt |
Specified torque: 15 Nm |
3 - | Nut |
Specified torque: 6 Nm |
4 - | Positive cable |
With battery terminal clamp |
Disconnecting and connecting → Chapter |
5 - | Cap |
For positive cable |
6 - | Heat shield sleeve |
7 - | Cover |
For positive battery terminal |
8 - | Cover |
For negative battery terminal |
9 - | Electrical connector |
For battery monitor control unit -J367- |
Observe specified sequence for work steps when connecting earth cable → Chapter |
10 - | Nut |
Specified torque: 9 Nm |
11 - | Earth cable |
12 - | Earth cable |
With battery terminal clamp and battery monitor control unit -J367- |
Removing and installing → Chapter |
Disconnecting and connecting → Chapter |
Adapting battery monitor control unit -J367- → Chapter |
13 - | Battery -A- |
Removing and installing → Chapter |
Disconnecting and connecting → Chapter |
Renewing (on vehicles equipped with Start/Stop system) → Anchor |
14 - | Battery tray |
Removing and installing → Chapter |
15 - | Bolt |
Qty. 3 |
Specified torque: 9 Nm |
Removing and installing model designation on radiator grille
Note
The description applies for all emblems. Here the “GTI”
emblem is shown as an example.
Removing
–
Removing radiator grille
→ Chapter
–  ...
Removing and installing reversing light bulb
Note
Removal and installation are described for the left side.
Removal and installation on the right side are carried out in
the same way.
Removing
–
Turn light switch to “0” position.
...
Removing and installing gas discharge bulb control unit -J343-/-J344-
WARNING
Risk of death due to high voltage! Risk of injury
and environmental pollution!
Observe operation and safety notes for gas discharge
bulbs
→ Chapte ...