1 - | Subframe |
2 - | Bolt |
Renew after removing |
70 Nm +180° |
3 - | Wheel bearing housing |
4 - | Track rod |
Removing and installing → Chapter |
5 - | Bolt |
Renew after removing |
Always tighten threaded connections in unladen position → Chapter |
70 Nm +180° |
6 - | Nut |
Renew after removing |
Aligning exhaust system free of tension
Procedure
The exhaust system must be aligned when cold.
Note
The -arrow- points forwards.
–
Loosen bolt connections for front clamp
...
Checking radial and lateral runout of wheels and tyres, tolerances
Radial and lateral run-out occur when the wheel and tyre do
not run absolutely true.
For technical reasons, 100% true running is not possible.
Therefore, the manufacturers of these components allow a
precisely determined ...
Removing and installing glove compartment light -W6-
Removing
–
Turn light switch to “0” position.
–
Press in locking lug -1- using
a flat screwdriver, and lever out glove compartment light
-2-.
...