Volkswagen Golf Service & Repair Manual: Assembly overview - toothed belt, engine codes CPTA, CHPA, CZEA, CZDA
Before removing, mark direction of rotation with chalk or
felt-tipped marker pen. |
Installing (adjusting valve timing), CPTA, CZEA
→ Anchor |
Installing (adjusting valve timing), CHPA, CZDA
→ Anchor |
Removal and installation involve removing engine support
→ Chapter. |
7 - |
Exhaust camshaft toothed belt pulley |
Removing and installing camshaft adjuster
→ Chapter. |
9 - |
Inlet camshaft toothed belt pulley |
Removing and installing camshaft adjuster
→ Chapter. |
Contact surface between toothed belt pulley and crankshaft must be
free from oil |
Fitting possible in one position only. |
Plug for “TDC” drilling in cylinder block - specified torque |
Note
– |
Tighten bolt -arrow- to 30 Nm. |
|
|
|
1 -
Lower toothed belt guard
2 -
Bolt
8 Nm
3 -
Engine support
Specified torque a ...
Special tools and workshop equipment
required
Torque wrench -VAS 6583-
...
Other materials:
Removing and installing spray jet, Golf
Note
The spray jet is installed in the high-level brake light.
Removing:
–
Remove high-level brake light
→ Chapter.
–&nbs ...
Removing and installing coolant pipes for auxiliary heater
Special tools and workshop equipment
required
Torque wrench -V.A.G 1410- (4…20 Nm)
Hose clamps, up to 25 mm -3094-
...
Waxing and polishing the vehicle
First read and observe the introductory information
and safety warnings Waxing
Waxing protects the paintwork. You will need to re-wax the vehicle with a good
hard wax if water no longer clearly forms small drops
and runs off the paintwork when it is clean.
Even if a wax solution is used re ...
© 2016-2024 Copyright www.vwgolf.org