Volkswagen Golf Service & Repair Manual: Assembly overview - three-point seat belt, estate, without belt tensioner
- Removing and installing
→ Chapter
- Removing and installing
→ Chapter
- If removed due to an accident with seat belt fastened, renew bolt
- 40 Nm
5 - |
Bolt for rear outer belt end fitting |
- If removed due to an accident with seat belt fastened, renew bolt
- 40 Nm
6 - |
Rear outer belt end fitting |
- Removing and installing
→ Chapter
1 -
Belt inertia reel
Removing and installing
→ Chapter
2 -
Electrical wiring harness
3 -
Bolt
...
1 -
Belt guide
Removing and installing
→ Chapter
2 -
Belt inertia reel
Removing and installing
→ Chapte ...
Other materials:
Assembly overview - toothed belt, engine codes CPTA, CHPA, CZEA, CZDA
1 -
Toothed belt
Before removing, mark direction of rotation with chalk or
felt-tipped marker pen.
Check for wear
Removing
→ Chapter
Installing (adjusting valve timing), CPTA, CZEA
& ...
Removing and installing dash panel central tube
Special tools and workshop equipment
required
Torque wrench -V.A.G 1331
Note
If electrical wires are disconnected or removed and
installe ...
Operating ParkPilot
Fig. 148 ParkPilot ultrasound sensors around
the vehicle, A: in the front bumper, B: in the rear bumper
Fig. 149 In the lower section of the centre
console: button for switching the ParkPilot on and off
First read and observe the introductory information
and safety warnings The ParkPilot ...
© 2016-2024 Copyright www.vwgolf.org