Volkswagen Golf Service & Repair Manual: Assembly overview - suspension strut, upper suspension link
Note correct installation position |
Different versions are possible. Refer to
→ Electronic Parts Catalogue “ETKA”. |
Tip of bolt must point in direction of travel. |
4 - |
Wheel bearing housing |
Different versions are possible. Refer to
→ Electronic Parts Catalogue “ETKA”. |
Different versions are possible. Refer to
→ Electronic Parts Catalogue “ETKA”. |
Removing and installing
→ Chapter |
Surface of spring coil must not be damaged. |
Different versions are possible. Refer to
→ Electronic Parts Catalogue “ETKA”. |
8 - |
Deep groove ball thrust bearing |
Different versions are possible. Refer to
→ Electronic Parts Catalogue “ETKA”. |
10 - |
Suspension strut mounting |
Note correct installation position
→ Anchor. |
Special tools and workshop equipment required
Torque wrench -V.A.G 1332-
Spreader -3424-
Engine and gearbox jack -V.A.G 1383 A-
...
Other materials:
Removing and installing cigarette lighter illumination bulb -L28-
Note
On some vehicles, the illumination is not provided by a
light bulb, but by an LED (light-emitting diode), depending on
the equipment level. This LED is permanently attached to the
retaining sleeve and cannot be renewed separately.
...
Removing and installing A-pillar trim
Special tools and workshop equipment
required
Removal wedge -3409
Torque wrench -V.A.G 1783
Removing
...
Changing the bulb in the number plate light
Fig. 241 In the rear bumper: number plate
light
Fig. 242 Number plate light: removing the
bulb holder
First read and observe the introductory information
and safety warnings
The actions should only be carried out in the specified order:
1. ...
© 2016-2024 Copyright www.vwgolf.org