Volkswagen Golf Service & Repair Manual: Assembly overview - suspension strut, shock absorber, spring, multi-link
suspension
Removing and installing
→ Chapter |
Note correct installation position of cable tie fastener.
|
Defective shock absorbers must always be degassed and drained before
disposal
→ Chapter |
Removing and installing
→ Chapter |
Assists with installation |
Turn end of spring against stop |
When installing, fit pin into aperture in spring mounting on lower
transverse link -arrow-. |
7 - |
Lower transverse link |
Always tighten bolted connection with suspension in unladen position
→ Chapter |
1 -
Bolt
Renew after removing
50 Nm +45°
2 -
Shock absorber
Removing and installing ...
Special tools and workshop equipment required
Torque wrench -V.A.G 1332-
Torque wrench -V.A.G 1410-
Spring compressor -V.A.G 1752/1 ...
Other materials:
Statutes and regulations
Note
The laws and regulations listed below are valid in the
Federal Republic of Germany. Other or additional laws and
regulations may apply in other countries.
Sources in other countries may be obtained from the
...
Recycling and scrapping end-of-life vehicles
First read and observe the introductory information
and safety warnings Recycling end-of-life vehicles
Volkswagen has already made provision for you to recycle your vehicle in an environmentally
responsible manner. The recycling system operating in many European countries will
take back you ...
Areas exposed to stone chipping
Body areas exposed to stone chipping
Note
The marked areas are exposed to stone chipping.
When sanding these areas, note thicknesses of the paint structure
and avoid sanding through. This is the only way to ensure long-term
corrosion protection.
...
© 2016-2024 Copyright www.vwgolf.org