Volkswagen Golf Service & Repair Manual: Assembly overview - suspension, multi-link suspension, four-wheel drive
3 - |
Wheel bearing housing |
Removing and installing
→ Chapter |
Removing and installing
→ Brake system; Rep. gr.46 |
Specified torque
→ Brake system; Rep. gr.46 |
Loosening and tightening
→ Chapter |
Before fitting, clean threads in stub axle using a thread tap. |
Removing and installing
→ Chapter |
The wheel bearing and wheel hub are assembled in one housing. |
This wheel bearing unit is maintenance-free and does not require
adjustment. Adjustments and repairs are not possible! |
Specified torque
→ Brake system; Rep. gr.46 |
Removing and installing
→ Brake system; Rep. gr.46 |
1 -
Wheel bearing housing
Removing and installing
→ Chapter
2 -
Bonded rubber bush
Renewing
& ...
1 -
Cover
2 -
Bolt
Renew after removing
50 Nm +45°
3 -
Mounting bracket
...
Other materials:
Repairing rain and light sensor, TRW
The housings for the rain and light sensors -G397- from
various manufacturers differ.
The sensor housing with lens unit is always supplied as a
replacement part in separate parts with retaining clips. In
vehicles which do not require the ...
Dimensions – lettering on wing
Note
The dimensions shown here for “GTI” as an example are valid for all
emblems.
1 -
Emblem
Variations in appearance possible depending on the (special) model.
2 -
Height dimension
5.0 ± 1 mm, fr ...
Adjusting assembly mountings
Procedure
–
Remove battery tray
→ Electrical system; Rep. gr.27.
–
Release hose clips -1- and
-2-, and remove air pipe.
...
© 2016-2024 Copyright www.vwgolf.org