1 - | Steering column |
Removing and installing → Chapter |
The centre punch marks -arrows- on the steering wheel and the steering column must align when reinstalling. Some steering columns leave the factory with no centre punch mark. On these steering columns a respective centre punch mark must be made before removing the steering wheel → Chapter. |
2 - | Steering wheel |
Removing and installing → Chapter |
Different versions possible. Refer to → Electronic Parts Catalogue |
The centre punch marks -arrows- on the steering wheel and the steering column must align when reinstalling. Some steering columns leave the factory with no centre punch mark. On these steering columns a respective centre punch mark must be made before removing the steering wheel → Chapter. |
3 - | Bolt |
Renew after removing |
30 Nm +90° |
Warning lamp
First read and observe the introductory information
and safety warnings
Lit up
Possible cause
Solution
Fault in the alternator.
Proceed to a qualified workshop. The electrical system
should be checked.
Switch off all elec ...
Removing and installing camshaft control valve 1 -N205- and exhaust camshaft
control valve 1 -N318-
Note
On engines with codes CMBA, CPVA, CXSA, CZCA and CPVB, only
camshaft control valve 1 -N205- is installed.
Removing
Inlet camshaft control valve 1 -N205-
–
Disconnect ele ...
Charging battery in maintenance mode with solar panel -VAS 6102A-
Solar panel VAS 6102A
General description:
Solar panel -VAS 6102A- supports onboard supply and prevents
spontaneous battery discharging.
Solar panel -VAS 6102A- achieves max. voltage of 14.3 V and
...