Volkswagen Golf Service & Repair Manual: Assembly overview - steering column switch module, with electronic ignition lock
| 1 - | Starter button -E378- |
| Overview of fitting locations → Chapter |
| 2 - | Steering column electronics control unit -J527- |
| With airbag coil connector and return ring with slip ring -F138- |
| Removing and installing → Chapter |
 Caution
|
| 3 - | Bolt |
| Qty. 3 |
| Specified torque: 1.1 Nm |
| 4 - | Mounting |
| With turn signal switch -E2-, intermittent wiper switch -E22- |
| Vehicles with cruise control system: with cruise control system switch -E45-. |
| Removing and installing → Chapter |
| 5 - | Control unit for electronic steering column lock -J764- |
| Removing and installing → Running gear, axles, steering; Rep. gr.48. |
| 6 - | Bolt |
| Specified torque: 1.1 Nm |
| 7 - | Steering column |
| 8 - | Bolt |
| Qty. 2 |
| For steering lock housing (shear bolt) |
| 9 - | Immobiliser reader coil -D2- |
| Removing and installing → Chapter |
| 10 - | Ignition key |
Assembly overview - steering column switch module, with mechanical ignition
lock
1 -
Ignition key
2 -
Lock cylinder
Removing and installing
→ Chapter
3 -
Immobiliser re ...
Removing and installing lock cylinder
Special tools and workshop equipment
required
Locking pin -T40011- or
suit ...
Other materials:
Checklist
Transporting children in the vehicle  :
Comply with any country-specific legal
regulations.
Volkswagen recommends that children under
12 years of age are always transported on the rear seats.
Children should only be transported on
the front passenger seat in exceptional ci ...
Removing and installing headlight range control unit -J431-/control unit for
cornering light and headlight range control -J745-, RHD vehicles
Note
When renewing the control unit, select
Renew function for the respective control unit in
Guided fault finding or
Guided functions mode
→ Vehicle
diagnostic tester.
Removing
â ...
Eliminating flat spots caused by storage or handling
Eliminating flat spots caused by storage or handling
Flat spots caused by storage or handling cannot be
eliminated from the tyre using workshop equipment.
Flat spots caused by storage or handling can be removed onl ...
