Volkswagen Golf Service & Repair Manual: Assembly overview - speed sensor on rear axle, front-wheel drive
Clean inside surface of hole before inserting sensor |
Coat inside surface with high-temperature paste -G 052 112 A3- |
Removing and installing
→ Chapter |
3 - |
Wheel hub with wheel bearing unit |
The ABS sensor ring is integrated in the wheel bearing unit. |
Check ABS sensor ring
→ Chapter |
Removing and installing
→ Running gear, axles, steering; Rep. gr.42 |
1 -
ABS speed sensor
Clean inside surface of hole before inserting sensor
Coat inside surface with high-temperature paste -G 052 112 A3-
...
1 -
ABS speed sensor
Clean inside surface of hole before inserting sensor
Coat inside surface with high-temperature paste -G 052 112 A3-
...
Other materials:
Brake fluid
Fig. 144 In the engine compartment: cap
on the brake fluid container
First read and observe the introductory information
and safety warnings Brake fluid will gradually absorb water from the surrounding
air. The brake system will be damaged if there is too much water in the brake fluid.
T ...
Wheel cover
Fig. 220 Removing the wheel covers
First read and observe the introductory information
and safety warningsRemoving the wheel covers
Take the box spanner and wire hook from the vehicle toolkit.
Insert the wire hook into one of the holes in the wheel cover.
Push the box spanner thr ...
Battery tester with printer -VAS 6161-
General description:
WARNING
Danger of injury! Observe warning notices and safety
regulations
→ Chapter!
It is not necessary to remove or ...
© 2016-2024 Copyright www.vwgolf.org