Volkswagen Golf Service & Repair Manual: Assembly overview - speed sensor on rear axle, all-wheel drive
Clean inside surface of hole before inserting sensor |
Coat inside surface with high-temperature paste -G 052 112 A3- |
Removing and installing
→ Chapter |
Assembly overview
→ Running gear, axles, steering; Rep. gr.42. |
Removing and installing
→ Running gear, axles, steering; Rep. gr.42. |
4 - |
Wheel hub with wheel bearing unit |
The ABS sensor ring is integrated in the wheel bearing unit. |
Check ABS sensor ring
→ Chapter |
Removing and installing
→ Running gear, axles, steering; Rep. gr.42 |
1 -
ABS speed sensor
Clean inside surface of hole before inserting sensor
Coat inside surface with high-temperature paste -G 052 112 A3-
...
The lateral acceleration sender -G200-, the yaw rate sender
-G202- and the longitudinal acceleration sender -G251- are
installed together with the control unit for el ...
Other materials:
Assembly overview – wiper motor and wiper frame
Note
The illustration shows fitting locations for LHD vehicles. Fitting
locations for RHD vehicles are similar.
1 -
Wiper motor
Removing and installing
→ Chapter
2 -
Bolts
...
Removing and installing rear door trim
Note
Removal and installation is described for the rear door trim
on driver side. Follow same instructions for the front passenger
side as appropriate.
Special tools and workshop equipment
required
...
Removing and installing seat heating element -Z6-/-Z8-
Removing
If the seat padding in a vehicle with seat heating is
renewed, then the respective seat heating element must also be
renewed.
–
Separate seat cover from seat ...
© 2016-2024 Copyright www.vwgolf.org