Volkswagen Golf Service & Repair Manual: Assembly overview - sliding sunroof

Volkswagen Golf Service & Repair Manual / General body repairs, exterior / Sliding roof / Sliding sunroof / Assembly overview - sliding sunroof

Assembly overview - sliding sunroof

1 -	Glass panel for panorama tilting sunroof (single pane safety glass)

Removing glass panel → Chapter
If drive defective, remove glass panel → Chapter
Adjusting glass panel → Chapter

2 -

Bolt

Bolts are microencapsulated and must always be renewed after loosening
Qty. 6
5.5 Nm

3 -	Seal of sliding sunroof frame

Removing and installing → Chapter.

4 -	Sunroof roller blind

Removing and installing → Chapter

5 -	Sliding sunroof frame

Removing and installing sliding sunroof frame → Chapter
Guide channels are to be greased, if required, with special grease G 060 751 A2 only otherwise correct operation cannot be guaranteed.

6 -

Bolt

For sliding sunroof motor
Qty. 3
4 Nm

7 -

Bolt

For sliding sunroof motor
Qty. 1
4 Nm

8 -	Sliding sunroof adjustment control unit -J245-

Removing and installing control unit → Chapter
Programming control unit → Chapter

9 -

Bolt

For the cover
Qty. 5
2.5 Nm

10 -

Cover

11 -

Bolt

Bolts are microencapsulated and must always be renewed after loosening
Qty. 13
3 Nm

12 -	Guide plate

With tilting mechanism and cables
Forms one component in conjunction with securing bracket of lift sun blind and control unit
Removing and installing → Chapter

13 -	Wind deflector

Removing and installing → Chapter.

14 -

Bolt

For wind deflector
Qty. 2
2 Nm

Sliding sunroof

...

Assembly overview - sunroof roller blind

1 - Sunroof roller blind Removing and installing → Chapter. 2 - Mounting For sunroof roller blind fabric 3& ...

Other materials:

Incorporation of high-voltage heater (PTC) - Z115- into coolant circuit
Note In vehicles with a high-voltage system, the high-voltage heater (PTC) -Z115- is used as a supplementary heater. In vehicles with a high-voltage system and an auxiliary heater installed as optional equipment, the ...

Assembly overview - exterior mirror
Note Only the left side is shown. The right side is similar. 1 - Mirror mounting Removing and installing → Chapter 2 - Bolt Qty. 2 9.0 Nm 3 - Clip 4&n ...

Removing and installing suction-jet pump
On vehicles with four-wheel drive the fuel tank is divided into a left and a right chamber. A suction-jet pump -2- is used for delivering fuel from the left fuel tank chamber to the baffle housing of the fuel delivery unit -1- on the right. ...