Volkswagen Golf Service & Repair Manual: Assembly overview - short noise insulation
Note
The removal and installation procedures may have to be modified
slightly depending on engine fitted. |
1 - |
Short noise insulation |
– |
Remove bolts -2- and
-3- |
– |
Pull out noise insulation off lock carrier to the back. |
- Qty. 3 on left
- Qty. 4 on right
- 2.0 Nm
Note
The removal and installation procedures may have to be modified
slightly depending on engine fitted.
1 -
Short noise insulation
Rem ...
Other materials:
Introduction
This chapter contains information on the following subjects:
→ Preparation for changing a wheel
→ Wheel bolts
→ Lifting the vehicle with the jack
→ Changing a wheel
→ After changing a wheel
Some models are delivered without a factory-fitted jack or bo ...
Assembly overview - condenser
Condenser, receiver
Note
The illustration shows the Modine condenser.
1 -
Condenser
Different versions. Refer to
→ Electronic Parts Catalogue.
Removing and installing
→ Cha ...
Separating control unit from hydraulic unit
Special tools and workshop equipment
required
ESD workplace -VAS 6613-
Torx bit T25
If a control unit is defective, separate it from the
hydraulic unit and renew only the control ...
© 2016-2024 Copyright www.vwgolf.org