Volkswagen Golf Service & Repair Manual: Assembly overview - rear centre three-point seat belt
- With rear belt switch, front passenger side -E259-
- Removing and installing
→ Chapter
- Always renew after belt tensioner has deployed with seat belt fastened
- Must rest flat against contact surface when tightening nut
- Removed due to an accident with seat belt fastened, renew nut.
- Specified torque 40 Nm
- Removing and installing
→ Chapter
5 - |
Rear centre belt guide |
- Renew complete belt guide if damaged
- To remove, push locking lugs inwards on both sides and pull out belt
guide
- When installing, push in belt guide until it audibly engages
6 - |
Right rear seat backrest (2/3) |
7 - |
Rear centre belt end fitting |
- Removing and installing
→ Chapter
1 -
Belt guide
Removing and installing
→ Chapter
2 -
Belt inertia reel
Removing and installing
→ Chapte ...
1 -
Left double belt buckle
With rear belt switch, driver side -E258-
Removing and installing
→ Chapter
Always renew after belt tensioner has depl ...
Other materials:
Checking function and voltage supply of the fuel pump, engine code CWVA
Special tools and workshop equipment
required
Removal wedge -3409-
Multimeter e.g. hand-held multimeter -V.A.G 1526E-
...
Seat belt routing
Fig. 66 Correct seat belt routing and head
restraint adjustment
Fig. 67 Correct seat belt routing during
pregnancy
First read and observe the introductory information
and safety warnings Seat belts only provide an optimum level of protection
during an accident when they are routed corr ...
Assembly overview - fog lights, GTI and GTD
1 -
Bolt
Specified torque: 2 Nm
2 -
Bolt
Specified torque: 2 Nm
3 -
Fog lights
These LEDs cannot be renewed. If one of the LEDs fails, the entire
fog light needs to ...
© 2016-2024 Copyright www.vwgolf.org