Volkswagen Golf Service & Repair Manual: Assembly overview - rear brakes
Assembly overview - rear brakes: |
Note
Use the brake filling and bleeding equipment -VAS 5234- to
draw off brake fluid from the brake fluid reservoir. |
Before removing a brake caliper or disconnecting a brake
hose, fit brake pedal depressor -V.A.G 1869/2- (when doing this,
release pressure in system). |
|
|
|
1 - |
Splash plate for brakes |
Allocation ⇒Electronic Parts Catalogue (ETKA) |
Never remove brake discs from wheel hub by force. If necessary use
penetrating fluid, because otherwise brake discs can be damaged. |
When worn, renew on both sides of axle. |
Remove brake caliper and brake carrier prior to removing. |
Do not disconnect brake hose when changing pads. |
Removing and installing
→ Chapter |
Following repair or replacement, perform “Basic setting” using
→ Vehicle
diagnostic tester. |
6 - |
Multi-point socket head bolt |
Remove and install using socket insert -T10035-
→ Fig.. |
Thickness: 11 mm not including backplate. |
Wear limit: 2 mm not including backplate. |
Checking thickness
→ Booklet. |
Always renew on both sides of an axle. |
Removing and installing
→ Chapter |
Thickness: 11 mm not including backplate. |
Wear limit: 2 mm not including backplate. |
Checking thickness
→ Booklet. |
Always renew on both sides of an axle. |
Removing and installing
→ Chapter |
Fitted only on inner brake pad |
Ensure correct installation position |
14 - |
Retaining spring for brake hose to bracket |
15 - |
Brake hose with banjo union and banjo bolt |
Connection to brake caliper, 35 Nm |
Connection to brake line, 14 Nm |
19 - |
Hexagon socket head bolt |
Removing and installing
→ Chapter |
Special tools and workshop equipment required
Vehicle diagnosis, testing and information system -VAS 5051-
Tool set for brake bleeding -VAS 6564-
...
Other materials:
Possible complaints about refrigerant circuit
Note
The air conditioning system is operating correctly if the
air emerging from the vent on the dashboard is at a temperature
of 7oC or less.
Set the Climatronic to: “LO”.
Set the ai ...
Removing and installing rear lid
Special tools and workshop equipment
required
Removing
Torque wrench -V.A.G 1331-
–
Remove upper rear lid trim
→ Genera ...
Cleaning seat belts
First read and observe the introductory information
and safety warnings Large particles of dirt on the automatic belt prevent
it from rolling back properly and thus from working effectively.
The seat belts must never be removed for cleaning purposes.
Remove dirt with a soft brush .
...
© 2016-2024 Copyright www.vwgolf.org