Volkswagen Golf Service & Repair Manual: Assembly overview - rear brake caliper
When carrying out repairs, install all parts supplied in
repair kit. |
Use only methylated spirits for cleaning the brake. |
New brake calipers are filled with brake fluid and are
pre-bled. |
|
|
|
5 - |
Hexagon socket head bolt |
Removing and installing not possible |
The compressor nut must not be unscrewed too far, since otherwise
the ball screw will be damaged. |
Removing and installing not possible |
Removing and installing not possible |
The piston must not be unscrewed too far, otherwise the ball screw
will be damaged. |
Removing and installing
→ Chapter |
Note
The brake caliper does not need to be removed in order to renew the
protective cap; do not unbolt the break hose. |
Apply thin coat of assembly paste G 052 150 A2 to thread before
screwing in. |
Special tools and workshop equipment
required
Removal wedge -3409-
...
Other materials:
Assembly overview - steering column trim
1 -
Dash panel
Assembly overview
→ Chapter
2 -
Gap cover
Removing and installing
→ Chapter
3 -
Upper steering column trim
Removing and installing
→ Chapter
...
Introduction
This chapter contains information on the following subjects:
→ Warning lamp
→ Preparing the vehicle for working in the engine compartment
→ Opening and closing the bonnet
Always park the vehicle on a level and stable surface before carrying out any
work in ...
Renewing bonded rubber bush for wheel bearing housing, four-wheel drive
Special tools and workshop equipment required
Assembly tool -3301-
Viscous fan fitting tool -3367-
Carrier -3390-
Torque wrench -V.A.G 1332-
Removing
– ...
© 2016-2024 Copyright www.vwgolf.org