1 - | Wheel bearing housing |
Different versions possible. Refer to → Electronic Parts Catalogue “ETKA” |
Removing and installing → Chapter |
2 - | Nut |
Renew after removing |
60 Nm |
3 - | Swivel joint |
Removing and installing → Chapter |
4 - | Nut |
Renew after removing |
Tighten in unladen position → Chapter. |
40 Nm +45° |
5 - | Lower suspension link |
Removing and installing → Chapter |
6 - | Front bonded rubber bush |
Renewing → Chapter. |
7 - | Bolt |
Renew after removing |
Tighten in unladen position → Chapter. |
70 Nm +180° |
8 - | Bolt |
Renew after removing |
70 Nm +180° |
9 - | Rear bonded rubber bush |
Renewing → Chapter. |
10 - | Nut |
11 - | Subframe |
Controls for the heating and fresh air system
Fig. 183 In the centre console: controls
for the heating and fresh air system
First read and observe the introductory information
and safety warnings
Button, control
Additional information. Heating and fresh air system
Temperature ...
Converting R12 refrigerant circuits to R134a refrigerant circuits and
repairing them (retrofitting)
Note
The laws and regulations listed below are valid in the
Federal Republic of Germany. Other or additional laws and
regulations may apply in other countries.
Sources in other countries may be obtained from the
...
EU tyre label, objectives
Reducing fuel consumption
Increasing road safety
Reducing traffic noise
The EU tyre label provides the end-user with important
information on the properties of the tyre. It does not
ill ...