Note| The assembly overview shows the locking mechanism for left rear seat back rest (1/3). The locking mechanism for the right rear seat backrest (2/3) is similar. |
| 1 - | Backrest frame |
| 2 - | Trim for locking mechanism |
| 3 - | Locking mechanism for rear seat backrest |
| 4 - | Bolt |
Assembly overview - rear seat backrest
Assembly overview - centre armrestAssembly overview - fuel tank, vehicles with fuel tank leak detection
1 -
Cap
Screw in until engages audibly
Secured to tank flap unit by means of retaining strap.
2 -
Earth connection
For fuel filler neck
3 -
Bolt
Renew ...
Raising wheel bearing assembly to unladen position (vehicles with coil
springs), rear axle
Special tools and workshop equipment required
Engine and gearbox jack -V.A.G 1383 A-
Tensioning strap -T10038-
Support -T10149-
Caution
All bolts on run ...
Removing and installing rear underbody cover – petrol/diesel
Note
The removal and installation procedures may have to be modified
slightly depending on engine fitted.
–
Loosen lock washer -3-.
–
Unclip spreader rivet -2- and remove
bolt -4-.
–
Remove rea ...