VW Golf manuals

Volkswagen Golf Service & Repair Manual: Assembly overview - knee airbag

Assembly overview - knee airbag

1 -  Knee airbag with driver side knee airbag igniter -N295-.
   Removing and installing → Chapter
  Caution
Any risk of damage to the knee airbag surface due to mechanical stress must be eliminated.
After completion of the repair work perform a visual check to ensure that the knee airbag surface is not damaged, particularly in the perforated area.
2 -  Contact point
   For knee airbag.
  Caution
Eliminate any risk of failure due to a faulty earth connection.
  •   Thread and contact surface must be free of paint, coatings and corrosion.
  •   The bolted connection is used as earth connection for the knee airbag.
3 -  Bolt
4 -  Electrical connections
  •  
For driver side knee airbag igniter -N295-.
Knee airbags
...

Removing and installing knee airbag with driver side knee airbag igniter -N295-
Removing   WARNING   Observe safety instructions for pyrotech ...

Other materials:

Draining refrigerant circuit using air conditioner service station
  WARNING High-voltage on high-voltage system. Danger of electric shock on air conditioner compressor! Models with a high-voltage system: now de-energise the high-voltage system ...

Assembly overview - FS III front brake
  Note After every brake pad change, depress brake pedal firmly several times with vehicle stationary, so that brake pads are properly seated in their normal operating position. Use the brake filling and bleeding equipment -VAS 5234- to draw off brake ...

Releasing gas and draining front gas-filled shock absorbers, DCC shock absorbers
–  Clamp gas-filled shock absorber vertically in vice.   WARNING Safety goggles must be worn when drilling. –  Drill a 3 mm hole -A ...

© 2016-2026 Copyright www.vwgolf.org