Volkswagen Golf Service & Repair Manual: Assembly overview - intake manifold
Clipped onto intake manifold. |
Removing and installing coolant pipe
→ Chapter |
Combined in one unit with charge air cooler |
Removing and installing
→ Chapter |
Clipped onto intake manifold. |
Specified torque and tightening sequence
→ Fig. |
6 - |
Intake manifold sender -GX9- |
|
Intake air temperature sensor 2 -G299- |
|
Intake manifold pressure sender -G71- |
Removing and installing
→ Chapter |
8 - |
Charge air pressure sender -GX26- |
|
Charge air pressure sender -G31- |
|
Intake air temperature sender -G42- |
Removing and installing
→ Chapter |
For removal, use release tools -T10527- and -T10527/1- |
Fit and screw in bolt by hand so that it screws into old thread Then
tighten bolt to torque |
16 - |
Throttle valve module -GX3- |
|
Throttle valve module -J338- |
|
Throttle valve drive for electronic power control -G186- |
|
Throttle valve drive angle sender 1 for electronic power control
-G187- |
|
Throttle valve drive angle sender 2 for electronic power control
-G188- |
Removing and installing
→ Chapter |
After throttle valve control module -GX3- has been replaced, it must
be re-adapted to engine control unit -J623-. Use vehicle diagnostic
tester for this. |
Intake manifold - specified torque and tightening sequence |
– |
Tighten bolts in stages as follows: |
|
|
|
Stage |
Bolts |
Specified torque |
1 |
-arrows- |
Starting in centre, screw in
bolts alternately by hand until they make contact |
2 |
-arrows- |
Starting in centre, screw in
bolts alternately: 8 Nm |
Special tools and workshop equipment
required
Release tool -T10527-
Release tool -T10527/1-
...
Other materials:
Vibration, vibration control system
Using the vibration control system -VAS 6230 A- you can
perform more functions than just stationary balancing.
A special feature of this system is the testing of the
radial force of the wheel and tyre while rolling.
A ro ...
Removing and installing rear fog light bulb -L46-/-L47-
Note
Removal and installation are described for the left side.
Removal and installation on the right side are carried out in
the same way.
Removing
–
Turn light switch to “0” position.
...
Removing and installing drive shaft
Special tools and workshop equipment
required
Torque wrench -V.A.G 1332-
Press tool -T10520-
...
© 2016-2024 Copyright www.vwgolf.org