Volkswagen Golf Service & Repair Manual: Assembly overview - impact bar
Volkswagen R GmbH, optional equipment, “R Line” and “R” |
|
|
|
- Different versions, allocation
→ Electronic Parts Catalogue “ETKA”
- Removing and installing
→ Chapter
- Vehicles with towing bracket
→ Chapter
- Qty. 4 on right
- Qty. 3 on left
- 20 Nm + 90°
- Is engaged in impact bar -1-
- Only installed in selected models available in selected markets
- Different versions, allocation
→ Electronic Parts Catalogue “ETKA”
Volkswagen R GmbH, optional equipment, “R Line” and “R”
Note
Different versions. ...
Volkswagen R GmbH, optional equipment, “R Line” and “R”
Note
The removal and installation procedures f ...
Other materials:
Tread depth and wear indicators
Fig. 202 Tyre tread: wear indicators
First read and observe the introductory information
and safety warnings Tread depth
Difficult driving situations demand the deepest possible tread depth for the
tyres and the same tread depth for the tyres on the front and rear axles. This applies
in ...
Tyre sizes for vehicles with four-wheel drive
The following points must be observed for vehicles with
four-wheel drive:
Only tyres of the same make, design and tread pattern may be
fitted to the front and rear axles.
Different tyre rolling circumferences ...
Removing and installing Blind Spot Monitor control unit J1086/J1087
Removing
–
Disconnect electrical connector -2-.
–
Unscrew nut -1- and bolts
-4- for bracket.
...
© 2016-2024 Copyright www.vwgolf.org