Volkswagen Golf Service & Repair Manual: Assembly overview - fuel rail with injectors
1 - |
Fuel pressure sender -G247- |
Removing and installing
→ Chapter |
Lubricate taper lightly with clean engine oil; do not lubricate
thread |
Removing and installing
→ Chapter |
The fuel system is under high pressure.Risk of injury due to fuel which may
spurt out.Release high pressure.
Unions must not show any signs of damage |
Removing and installing
→ Chapter |
Removing and installing
→ Chapter |
Fuel rail exerts force which secures injector in cylinder head via
this support ring |
Lubricate with clean engine oil. |
Removing and installing
→ Chapter „Removing and installing injectors“ |
9 - |
Combustion chamber seal |
Do not treat with grease or other lubricant. |
Renew
→ Chapter „Removing and installing injectors“ |
Removing
The fuel system is under high pressure.Risk of injury due to fuel which
may spurt out.Release high pressure.
→ Chapter
...
Other materials:
Removing and installing heat exchanger for high-voltage battery
Special tools and workshop equipment
required
Hose clamps, up to 25 mm -3094-
Engine bung set -VAS 6122-
Pliers for spring-type clips -VAS 5024A-
Cooling sy ...
Driving with an automatic gearbox
First read and observe the introductory information
and safety warnings The gearbox changes the forward gears up and down automatically.
Driving down hills
The steeper the gradient, the lower the gear you will need. Lower gears increase
the braking effect of the engine. Never allow the vehic ...
Removing and installing protective cap
Special tools and workshop equipment
required
Removal wedge -3409-
Thrust piece -T10502- for rear brake FNc-M38 (15”)
...
© 2016-2024 Copyright www.vwgolf.org