Volkswagen Golf Service & Repair Manual: Assembly overview - front three-point seat belt, 2-door model

Volkswagen Golf Service & Repair Manual / General body repairs, interior / Pasanger protection / Seat belts / Assembly overview - front three-point seat belt, 2-door model

Assembly overview - front three-point seat belt, 2-door model

1 -

Bolt

If removed due to an accident with seat belt fastened, renew bolt.
20 Nm

2 -	Belt end fitting

Removing and installing → Chapter

3 -

Bolt

If removed due to an accident with seat belt fastened, renew bolt
40 Nm

4 -	Belt inertia reel

Driver side: with driver seat belt tensioner igniter 1 -N153- and control unit for front left belt tensioner -J854-
Front passenger side: with front passenger seat belt tensioner igniter 1 -N154- and control unit for front right belt tensioner -J855-.
Removing and installing → Chapter
For vehicles with control unit for front left belt tensioner -J854- or control unit for front right belt tensioner -J855-, the airbag control unit -J234- must be adapted in → Guided fault finding after renewing the seat belt. If the → Guided fault finding is already running, then refresh test plan “15 - Airbag”.

5 -

Bolts

Qty. 2
4.5 Nm

6 -	Front belt guide

Removing and installing → Chapter
Observe correct installation position when installing.

7 -

Bolt

If removed due to an accident with seat belt fastened, renew bolt.
40 Nm

8 -	Belt guide fitting

Must move to vertical position or operated position on its own after bolt has been tightened

9 -

Bolt

If removed due to an accident with seat belt fastened, renew bolt.
20 Nm

10 -	Belt height adjustment

Removing and installing → Chapter
Always renew after belt tensioner has deployed with seat belt fastened

11 -

Washer

12 -

Bolt

If removed due to an accident with seat belt fastened, renew bolt
40 Nm
Start bolt by hand when installing

13 -	Retaining loop

Overview of fitting locations - seat belts and anchorage points, estate

1 - Front belt buckles Assembly overview → Chapter Removing and installing → Chapter 2 - Front belt end anchor ...

Assembly overview - front three-point seat belt, 4-door model and estate

1 - Bolt If removed due to an accident with seat belt fastened, renew bolt. 40 Nm 2 - Belt end fitting Removing and installi ...

Other materials:

Removing and installing inner door cover
Special tools and workshop equipment required Note Removal and installation are described only for the left cover. The right side is similar. Removing ...

Removing and installing tank pressure sensor -G400
Removing Note The tank pressure sensor -G400- is located in the pressure regulating valve on the activated charcoal filter → Chapter. – Remove activated charcoal filter → ...

Towing attachment type plate
The trailer load and drawbar load details on the type plate of the towing attachment are test figures for the device. The approved details for the relevant vehicle could be below the trailer load and drawbar load specifications of the trailer. Figures ca ...