Volkswagen Golf Service & Repair Manual: Assembly overview - fog lights, GTI and GTD
These LEDs cannot be renewed. If one of the LEDs fails, the entire
fog light needs to be renewed. |
Removing and installing
→ Chapter |
Assembly overview - fog lights, Golf
1 -
Fog lights
Different versions. Refer to
→ Electronic Parts Catalogue.
Removing and ...
Note
Removal and installation are described for the left side.
Removal and installation on the right side are carried out in
the same way.
...
Other materials:
Removing and installing wheel bearing housing, multi-link suspension,
four-wheel drive
Special tools and workshop equipment
required
Torque wrench -V.A.G 1332-
Engine and gearbox jack -V.A.G 1383 A-
...
Replacing the battery
Fig. 25 Vehicle key: opening the battery
case cover
Fig. 26 Vehicle key: removing the battery
First read and observe the introductory information
and safety warnings Volkswagen recommends having the battery changed by a
qualified workshop.
The battery is located on the rear side of the ...
Contact corrosion
Contact corrosion can occur if unsuitable fasteners (bolts,
nuts, washers, etc.) are used.
Therefore, only fastening elements with a special surface
coating are installed in the vehicle.
In addition, rubber and plastic p ...
© 2016-2024 Copyright www.vwgolf.org