Volkswagen Golf Service & Repair Manual: Assembly overview - evaporator housing

Volkswagen Golf Service & Repair Manual / Heating, air conditioning / Air conditioner / Front heater and air conditioning unit / Assembly overview - evaporator housing

Note

There are different designs and makes of heater and air conditioning unit. The individual components of the various heaters and air conditioning units are similar but not identical. The combined fitting of different makes of component is therefore not permissible → Electronic Parts Catalogue.

The following illustration shows a “Valeo” evaporator housing, distinguishing features with respect to other makes of heater and air conditioning unit → Chapter.

The illustration shows a left-hand drive vehicle.

Assembly overview - evaporator housing

1 -	Evaporator housing, lower part

2 -	Evaporator

Only if air conditioning system is fitted.

Check foam seals for damage and proper attachment

Removing and installing → Chapter.

3 -	Sealing ring

Only on vehicles with air conditioning system.

Renewing; for versions, refer to → Electronic Parts Catalogue.

Before fitting a seal, coat lightly with refrigerant oil

4 -	Retaining plate

Only if air conditioning system is fitted.

For securing refrigerant lines and expansion valve.

5 -	Expansion valve

Only if air conditioning system is fitted.

Removing and installing → Chapter.

6 -

Bolt

Only if air conditioning system is fitted.

Qty. 2.

10 Nm

7 -	Sealing and insulation

Heat insulation for expansion valve.

There is no opening for the expansion valve in the plenum chamber back wall seal or this is closed off by a foam pad on vehicles with no air conditioner

8 -	Sealing ring

Only on vehicles with air conditioning system.

Renewing; for versions, refer to → Electronic Parts Catalogue.

Before fitting a seal, coat lightly with refrigerant oil

9 -

Bolt

Qty. 8.

1.5 Nm

10 -	Evaporator housing, upper part

11 -	Flow rate limiter

Only on vehicles with no air conditioning system installed

Assembly overview - add-on parts of heater and air conditioning unit and of air intake box

Note There are different designs and makes of heater and air conditioning unit. The individual components of the various heaters and air conditio ...

Assembly overview - flaps and partitions in air distribution housing

Note The illustration shows a left-hand drive vehicle. View from front Note -Arrow-&nbs ...

Other materials:

Rear axle
Overview - rear axle, torsion beam axle I - → Chapter „Axle beam“ II - → Chapter „Suspension strut, shock absorber, spring“ III - → Chapter „Wheel bearing assembly, trailing a ...

Leaks at shock absorbers
Shock absorbers are often replaced because of externally visible leakage. Inspections on the test rig and in the vehicle have shown that in the majority of cases this replacement is not justified. Slight loss of fluid (“sweating”) at ...

General description of Midtronics -INC 940- battery tester
Batteries in VW vehicles may only be charged with battery chargers approved by VW. In the USA/Canada, it is permitted for the Midtronics -INC 940- battery charger to be used. Midtronics -INC 940- battery charger combines battery charging ...