VW Golf manuals

Volkswagen Golf Service & Repair Manual: Assembly overview - engine oil cooler

Assembly overview - engine oil cooler

1 -  Engine oil cooler
See note → Chapter
Removing and installing → Chapter
Change coolant after renewing.
2 -  Bolt
Renew
8 Nm + 90°
3 -  Oil seals
Renew
Engine oil cooler
...

Removing and installing engine oil cooler
Removing –  Drain coolant → Chapter. –  Remove intake manifold → Chapter ...

Other materials:

Assembly overview - poly V-belt drive, vehicles without air conditioner compressor
1 -  Bolt Renew 150 Nm +180° Use counterhold -T10475- to loosen and tighten. Risk of damage to engine caused by incorrect valve timing.Do not turn crankshaft out of TDC position. 2 -  ...

Removing and installing fuel tank flap release button -E319-
Special tools and workshop equipment required     Removal wedge -3409-   Note The removal and installation procedures are described for LHD vehicles. Removal and ins ...

Assembly overview - brake pedal, LHD vehicles
  Note The handbrake pedal travel must not be restricted by additional floor coverings. Do not lubricate or grease the pivot pin. The pivot pin must remain dry.     1&n ...

© 2016-2026 Copyright www.vwgolf.org