Volkswagen Golf Service & Repair Manual: Assembly overview - dual clutch
For large engaging lever “K 1” |
For small engaging lever “K 2” |
Removing and installing
→ Anchor |
Determining thickness
→ Chapter |
Determining thickness
→ Chapter |
5 - |
Small engagement bearings for “K 2” |
Removing and installing
→ Chapter. |
Always renew after removing. |
10 - |
Large engaging lever for “K 1” |
Removing and installing
→ Chapter |
11 - |
Upper section of bushing |
For small engaging lever “K 2” |
Is removed and installed together with small engaging lever and
lower section of bushing |
12 - |
Small engaging lever for “K 2” |
Is removed and installed together with upper and lower section of
bushing |
Removing and installing
→ Chapter |
Always renew after removing. |
14 - |
Lower section of bushing |
For small engaging lever “K 2” |
Is removed and installed together with small engaging lever and
upper section of bushing |
15 - |
Oil seal for inner input shaft |
Special tools and workshop equipment required
Hook -3438-
Engine bung set -VAS 6122-
Support device -T10323-
-T10356/5- ...
Other materials:
Overview of fitting locations - components inside of front passenger
compartment, RHD vehicles
1 -
Air recirculation flap control motor -V113- or fresh air/recirculated
air, air flow flap control motor -V425-
Removing and installing air recirculation flap control motor -V113-
→ Chapter
Removing and installing fres ...
Removing and installing Denso belt pulley
Note
The pulley is sensitive to impact and should therefore be
treated with extreme care.
If the belt pulley overload protection has deployed, check
freedom of movement of air conditioner compressor before
rene ...
Warning lamp
First read and observe the introductory information
and safety warnings
Display
Possible cause
Solution
Any or all vehicle doors are open or not closed properly.
Do not drive
on!
Open the appropriate vehicle door and th ...
© 2016-2024 Copyright www.vwgolf.org