Volkswagen Golf Service & Repair Manual: Assembly overview - driver side airbag

Volkswagen Golf Service & Repair Manual / General body repairs, interior / Pasanger protection / Driver side airbag / Assembly overview - driver side airbag

Assembly overview - driver side airbag

1 -

Catch

To release, use a Torx screwdriver T25 of approx. 100 mm length

2 -	Steering column electronics control unit -J527-

With airbag coil connector and return ring with slip ring -F138-
Assembly overview → Electrical system; Rep. gr.94

3 -	Steering wheel without multifunction button

Equipment version
Assembly overview → Running gear, axles, steering; Rep. gr.48

4 -	Wiring harness without wires for multifunction button

For driver side airbag igniter -N95
Renewing → Chapter
Press into recesses in steering wheel to secure it.

5 -	Driver side airbag

With driver side airbag igniter -N95-

WARNING

Observe safety instructions for pyrotechnic components → Chapter.

Removing and installing → Chapter

6 -

Bolt

Tightening torque → Running gear, axles, steering; Rep. gr.48

7 -	Steering wheel with multifunction button

Equipment version
Assembly overview → Running gear, axles, steering; Rep. gr.48.

8 -	Wiring harness with wires for multifunction button

For driver side airbag igniter -N95
Renewing → Chapter
Press into recesses in steering wheel to secure it

9 -	Driver side airbag

With driver side airbag igniter -N95-

WARNING

Observe safety instructions for pyrotechnic components → Chapter.

Removing and installing → Chapter

10 -

Bolt

Tightening torque → Running gear, axles, steering; Rep. gr.48

Driver side airbag

...

Removing and installing driver side airbag igniter -N95-

Special tools and workshop equipment required Commercially available Torx screwdriver T25 of approx. 100 mm length ...

Other materials:

Vehicle lifting points
Fig. 205 Lifting point at front for the lifting platform or vehicle jack Fig. 206 Lifting points at rear for the lifting platform or vehicle jack First read and observe the introductory information and safety warnings The vehicle may only be lifted at the points shown in the illustrati ...

Removing and installing valve, rubber valve
Ensure that the wheel rim is clean. – Insert new tyre valve with -VAS 6459--1-. – Unscrew and remove valve insert. – Infl ...

Assembly overview - lower rear lid trim
1 - Rear lid 2 - Bolt Qty. 4 1.5 Nm 3 - Lower rear lid trim Removing and installing → Chapter 4 - Retaining clip Insert into trim Remove any retaini ...