Volkswagen Golf Service & Repair Manual: Assembly overview - drive shaft, triple roller joint AAR3300i
Loosening and tightening
→ Chapter |
Before fitting, clean the threads in the CV joint using a thread
tap. |
2 - |
Outer constant velocity joint |
Renew only as complete unit |
Installing: drive onto shaft with plastic hammer until compressed
circlip seats |
Insert in groove in shaft |
5 - |
Boot for constant velocity joint |
Check for splits and chafing |
Material: Hytrel (polyester elastomer) |
8 - |
Triple roller star with rollers |
The chamfer -arrow- points towards
drive shaft splines. |
Insert in groove in shaft |
11 - |
Boot for triple roller joint |
Check for splits and chafing |
15 - |
Multi-point socket head bolt |
Initially tighten diagonally to 10 Nm and then tighten diagonally to
specified torque. |
Insert in groove in shaft |
1 -
Bolt
Renew after removing
Loosening and tightening
→ Chapter
Before fitting, clean the threads in the C ...
Special tools and workshop equipment
required
Torque wrench -V.A.G 1332-
...
Other materials:
2-pack wash primer
Designation:
2-pack wash primer -LLS MAX 230 M1-, olive-green (250 ml)
Issued 12.2013
Product description
The 2-pack wash primer -LLS MAX 230 M1- is a zinc
chromate-free ...
Assembly overview - front brakes
Note
After every brake pad change, depress brake pedal firmly
several times with vehicle stationary, so that brake pads are
properly seated in their normal operating position.
Use the brake filling and bleeding equip ...
Aligning exhaust system free of tension
Procedure
The exhaust system must be aligned when cold.
Note
The -arrow- points forwards.
–
Loosen bolt connections for front clamp
...
© 2016-2024 Copyright www.vwgolf.org