Volkswagen Golf Service & Repair Manual: Assembly overview - drive shaft

Volkswagen Golf Service & Repair Manual / Running gear, axles, steering / Rear suspension, drive shaft / Drive shaft / Assembly overview - drive shaft

Assembly overview - drive shaft

1 -	Outer constant velocity joint

Renew only as complete unit

Removing → Fig..

Installing: drive onto shaft to stop using plastic hammer

Distribute grease evenly in joint

Checking → Chapter

2 -

Bolt

Renew after removing

Before fitting, clean the threads in the CV joint using a thread tap.

200 Nm +180° → Chapter

3 -	Drive shaft

Allocation → Electronic Parts Catalogue.

4 -

Clamp

Renew after removing

Tightening → Fig.

5 -

Boot

Check for splits and chafing

Material: Hytrel (polyester elastomer)

6 -

Clamp

Renew after removing

Tightening → Fig.

7 -	Dished spring

With inner splines

Installation position → Fig.

8 -	Retaining ring

Renew after removing

Insert in groove in shaft

9 -	Boot for constant velocity joint

Material: Hytrel (polyester elastomer)

Without breather hole

Check for splits and chafing

Drive off constant velocity joint with a drift

Coat sealing surface of constant velocity joint with -D 454 300 A2- before installing.

10 -

Clamp

Renew after removing

Tightening → Fig.

11 -	Locking plate

12 -	Multi-point socket head bolt

Renew after removing

Initially tighten diagonally to 10 Nm and then tighten diagonally to specified torque.

40 Nm

13 -

Cover

Renew after removing

Always renew

Pressing off → Fig.

14 -	Retaining ring

Renew after removing

Remove and install with circlip pliers -VW 161 A-.

15 -

Seal

Renew after removing

Adhesive surface on constant velocity joint must be free of oil and grease!

16 -	Inner constant velocity joint

Renew only as complete unit

Distribute grease evenly in joint

Pressing off → Fig.

Pressing on → Fig.

Checking → Chapter

17 -	Dished spring

With inner splines

Installation position → Fig.

Drive shaft

...

Removing and installing drive shaft

Special tools and workshop equipment required Torque wrench -V.A.G 1332- ...

Other materials:

Introduction
This chapter contains information on the following subjects: → Display and warning and indicator lamp → Operating the speed limiter The speed limiter helps the driver not to exceed an individual stored speed when driving forwards at speeds of approximately 30 km/h (20 m ...

Undercoating, additional protected areas on CNG-powered vehicles
Note Undercoating (stone-chipping protection) applied during repair work must be identical in appearance and thickness to the original undercoating. Water drainage holes must remain clear. All threaded studs and welded nuts with metric ...

Assembly overview - control units, RHD vehicles
1 - Bracket For onboard supply control unit -J519- Removing and installing → Chapter 2 - Onboard supply control unit -J519- Removing and installing → Chapter ...