Volkswagen Golf Service & Repair Manual: Assembly overview - control unit and hydraulic unit, LHD vehicles
1 - |
ABS control unit -J104- |
Removing and installing
→ Chapter. |
2 - |
ABS hydraulic unit -N55- |
Removing and installing
→ Chapter. |
Tighten new Torx bolts alternately in 2 stages |
1. stage: temporary tightening torque: 1 Nm to 1.5 Nm (to allow the
seal to settle). |
2. stage: final specified torque: 2.5 Nm. |
To rear right brake caliper. |
Identification: 5.25 mm in diameter and union nut with thread M 12 x
1 |
To front left brake caliper. |
Identification: 5.25 mm in diameter and union nut with thread M 10 x
1 |
To front right brake caliper |
Identification: 5.25 mm in diameter and union nut with thread M 12 x
1 |
To rear left brake caliper. |
Identification: 5.25 mm in diameter and union nut with thread M 10 x
1 |
From primary piston circuit of brake master cylinder to hydraulic
unit. |
Identification: 6 mm in diameter, union nut with thread M 12 x 1 |
From secondary piston circuit of brake master cylinder to hydraulic
unit. |
Identification: 6 mm in diameter and union nut with thread M 12 x 1 |
Removing and installing
→ Chapter. |
Ensure that rubber dampers of retainer are not pressed out of
bracket when installing. After installation, check that the ABS
hydraulic unit -N55- is firmly seated, or malfunction can occur. |
Allocation
→ Electronic Parts Catalogue (ETKA). |
1 -
Brake line
From secondary piston circuit of brake master cylinder to hydraulic
unit.
Identification: 6 mm in diameter and unio ...
Other materials:
Bleeding hydraulic system following standard procedure
Note
Bleeding the hydraulic system using brake filling and
bleeding equipment -VAS 5234- is described.
A pre-pressure of 2 bar is required for bleeding the ABS
hydraulic unit -N55-.
Specia ...
Restrictor
The restrictor creates a restriction. This restriction
limits the flow, separating the high-pressure and low-pressure
sides in the refrigerant circuit. Upstream of the restrictor,
the refrigerant is warm due to the high pressure. Downstream of
the restri ...
Removing and installing switch module in centre console -EX23-/-EX30-
Special tools and workshop equipment
required
Removal wedge -3409-
Caution
Danger of damage to component surfaces.
...
© 2016-2024 Copyright www.vwgolf.org